Galling in Stainless Machining: Causes and Fixes
You are halfway through turning a 304 stainless shaft when the surface comes out scored, the hole comes…
Read more →
You are halfway through turning a 304 stainless shaft when the surface comes out scored, the hole comes…
Read more →
Chemical conversion coating — also called chem film, chromate conversion coating, Alodine, or Iridite — is one of…
Read more →
A mill runs well when the cutter sees the surface speed and chip load its geometry was designed…
Read more →
Optical parts punish small errors other industries ignore. A lens cell with a bore off-center by 20 microns,…
Read more →
Medical parts look simple in a render and are nearly impossible on a 3-axis mill. An orthopedic implant,…
Read more →
Every shop faces the same question when a new part arrives: can the 3-axis mill handle it, or…
Read more →
G10 and FR4 look like flat green or tan laminate board and machine like something between epoxy and…
Read more →
Copper is a machinist’s headache dressed as an electrical engineer’s best friend. It carries current, conducts heat, and…
Read more →
A plastic prototype arrives in two to three days and costs a fraction of the aluminum version. It…
Read more →